Basic HTML Version
Torrington, CT 06790 • USA • TEL: 860-482-1532 • FAX 860-482-5059 • www.norse-inc.com © 2008
TORRINGTON, CT USA
TDS 108-1
V2-1106
TYPE 3 LATCH S1500-3-1.000 AND
TYPE 3 RECEIVER R500 -3-500
FOR EXHIBITS, STORE FIXTURES, OFFICE PANELS, PREFAB STRUCTURES, ETC.
THIS IS THE MOST FREQUENTLY USED TYPE 3 LATCH RECEIVER COMBINATION FOR THICK PANEL FABRICATION
APPLICATIONS
Fig 1:
Typical thick and thin panel
fabrication using Type 3 Latches and
Receivers for In-Line Butt joints,
corners and ‘T’ joints.
Fig. 5B
Fig. 5A
Fig. 6
Fig. 4
Fig 2A & 2B:
The Type 3 Latch S1500-3-1.000 & Type 3 Receiver
shown in these cutaway views of a flange-to-flange mounting in
3/4”/19mm thick framing places the access hole behind the frame.
Fig 3:
This photo of two
3/4”/19mm framing sections
joined by this Type 3
Latch/Receiver combination
shows clearly that the key
access is well behind the frame.
Mounting Dimensions
Type 3 Latch:
S1500-3-1.000
Type 3 Receiver:
R500-3-500
When locking
: First rotate the Latch
away from
the Receiver until it stops, this extends the
‘Reach’ of the spring hook for locking
.
Latch Dimensions
Type 3 Latch:
S1500-3-1.000
Receiver Case Dimensions Identical
COCK IT BEFORE
YOU LOCK IT
See
TDS
1-1.
Case flanges are recessed flush
with framing face.
The Hex Key access hole is
clear of the .750”/19mm
framing member due to the
1.000” ‘Setback’ of the
Latch case. Also, the Latch
and Receiver can be set in
place after the panels are
complete.
Mounting
Type 3 Latch:
S1500-3-1.000
Type 3 Receiver:
R500-3-500